Hello All. It is unfortunate that my first post is to sell parts and not to ask how to fix them up. I've had some of these parts for almost 20 years now, and it is obvious that I will never do anything with them. They need to go to someone who can use them, and it would be nice to have them out of my garage. I've never become knowledgeable enough to verify that everything I have is BBB. When I bought the parts I was told they were BBB, and I believe them all to be BBB. HOWEVER, please let me know if I have something labeled incorrectly. If I do, I didn't do it on purpose, it was simply because I didn't know. For location of these parts use 17046. To contact me please use steve@e-emetalfab.com. Pictures of the parts can be seen here: http://www.e-emetalfab.com/SteveAnn/Big_Block_Buick.htm BBB PARTS FOR SALE - Please feel free to make offers: 1971 LaSabre 455 Engine, complete from Carb to pan, pulled from Demo Car - $375.00 -- SOLD 400T Trans, from 71 LaSabre, Long Tailshaft - $150.00 Manual Flywheel - $150.00 GM Steel Head Gaskets, P/N 1-1236030 - $75.00 pair Auto Flexplate - $30.00 -- SOLD Valve Covers - Free to first purchaser (plus shipping if necessary) Rocker Assemblies - $40.00 pair 30 pushrods, 0.312 OD, ~9.343 Long, some have P/N 48138 - $30 for all M/T ET Drag Slicks, 3 passes, 29.5 X 10.5W - $300.00 pair Like I said, please feel free to make offers. Thank for looking, Steve
You know, I had the number of teeth written down somewhere, now I can't find it. I will count the teeth tonight again and let you know tomorrow morning. From the pics you can see it hasn't been heated up, and the starter teeth are pretty good. It did have some surface rust on it that I cleaned off before I took the pics. I can put a straight edge on it tonight and feeler gage any gap and let you know tomorrow. If you would like more specicifc pics of it, just let me know. Thanks, Steve
Everyone, are you able to get into my picture page thru the link above? I'm not allowed to insert the complete link until I have 10 posts. All you have to do is copy and paste that into your web browser and that should take you to the picture page. Let me know if that works or you have any other questions. Thanks, Steve
I just checked my PM box, and I didn't recieve your message. Can you try again, or email me at the email address listed above in the first post? Thanks, Steve
The flywheel has 166 teeth. The leading edge on all the teeth are slightly worn from use, but nothing bad. Please see pic of teeth. There is nothing worse then what is shown in the pic. When I straight edged it, I could fit a 0.010 feeler gage under it towards the center. I would think a light resurfacing and it would be good to go. None of the threaded holes for the pressure plate are stripped and they all look good. Thanks for looking, Steve
Somewhere in the mid 1990's, can't remember exactly. If I had to guess I would say 1994. Thanks, Steve
The 455 engine is sold. So is the the Flexplate. Please make offers on anything you might want. No offer is unreasonable, I would like everything to go away. All items will be sold to the highest bidder no matter what the offer. Plus shipping. Thanks, Steve
