Nice HEI. I ran this until I switched over to a serpintine belt setup and there was not enought room for it. The gear is perfect, housing is polished, cap is the remote coil style. Has an Accell module in it and the curve worked well with the 113 cam I ran it with. Less than 2000 miles on cap, rotor and module. $95 plus shipping
I have not run this for a few years so cannot be sure (this memory thing as you get older sucks.) It has a curve kit in it and it is all in by 2000 rpm. I know that it has the big bushing in it to help limit the advance. If I remember correctly I ran 16* initial and 34* total on that motor. So that puts it about 18* I do know that it was a nice curve for the Postons 113 cam. The TA 413 in my new motor wants more initial with a little slower curve. Now I just weld up the slot and grind it back to what I want. I will also send the stock cap with a coil in it. Should be good but cannot say for sure. It has this module in it. Accel 33567