455 machined main caps for ta girdle

I Have A Set Of 455 Main Caps That Were Used With A Ta Block Girdle. 75.00 or obo Shipped Thanks Joe Riv Plainfield Il

 

Joe, is there any way to know if these caps will have enough meat left to survive another line bore/hone plus the rest of the procedures for girdle instalation? I know some measurements have to be taken after the block is prepped but before the caps are milled to get the crush just right.

Devon

 

Devon, i know it was line honed once. I don't have any tools to mesure them but a tape if that will help sorry joe

 

Thanks anyway Joe, I think I'll just stick with what I have. My girdle instructions seem to point out that with a fresh install, there is only enough material on the caps for one aline bore after everything else is set up. Maybe someone else can correct me if I'm reading it wrong.

Devon

 

Devon you have a PM

 

Replied. I'll have to pass but thank you for the offer!

Devon

 

Joe, What did you do with the bearings?

I need some for crank location only. Not to be run.

 

sorry don't have them.

 

ttt