***1250 3-Circuit Dominator- Worked great! They no longer make this 3-circuit which was a big brother to the popular 1050 2x4 carb that worked well on the 455. $600***Sold*** Cam girdle $150 ***SOLD*** Front cover with Peterson Wet/Vac, drive setup, ATI balancer, Mag pickup, alternator, Moroso belt drive Alt, with lines and filter. $1500***Sold*** TA lifters with oil restrictors-$200 $1000 billet roller cam-bought as a raw core, pre-cut, then heat treated, then final cut. 266/278 .765/.740" 112LSA has surface rust but its a roller and should be fine cleaned up. $200 Aluminum valve covers with AN fittings-$100 ***SOLD*** R&R aluminum rods 6.8, stock 455 journal-$250 just reconditioned***Sold*** MSD 455 distributor, needs a new gear- $195 with wires and large Pro cap***SOLD*** 12-908P-10 main bearings- $50
Rick, if the alum conrods have a 1" wrist pin opening I will buy them. Edit: I will buy them Rick as I need new pistons either way.
Inline for dist.....would like the part number and to see pictures. Do you remember what part number the msd crank trigger is......did you have to clearance the timing tab to get the ati dampner fit. If you would be interested in sell the trigger seperator would be interested in that too
MSD crank trigger is only selling as a complete assembly with the front cover setup. It was all a running setup on my 466... Cam girdle is open to buy by itself.... Distributor is a MSD 8715 Pro Billet
Rick, please calculate shipping to 18847. Send a PM with address and I will get a postal money order out to you ASAP. Thank you, George
Also have my Stg3 Dominator style intake that I used to run. Comes with a 2" HV Dominator spacer, drilled for a fogger that used to be on it, has the water bypass setup, and vacuum relief check valve on the rear of the intake. Nitrous system is removed... My current picture of it wont load that I took of it... $300