I have a '72 Skylark shell that I put some work into. Unfortunately, life and time has gotten in the way and this must go to make room for the next interest. The body was blasted and coated in epoxy primer. I replaced the trunk floor with an aftermarket piece. The floor under the rear seat has been replaced as well as the front floor sections. In all cases, the supporting braces were cleaned, painted, and prepped with weld-thru primer prior to placing the new panel. The DS quarter is original and very solid. The passenger side quarter is also original but needs some work. The trunk drop on the DS is solid. The PS is a little thin but repairable. The roof is solid as well. The top of the cowl looked like swiss cheese so I removed it at the spot-welds and cut along the windshield channel. A replacement piece will be included. Again, this is just the shell. $800 -- Located about 20 miles East of Pittsburgh, PA