Hello all, Just spent all of the winter and most of the summer doing the body on my 63 lesabre vert. Sanded the entire car with 220 and then 320. all surface rust was sanded down to bare metal and feathered. Then Primed with an etching primer. All holes and previous repairs were fixed and primed with same primer. Here is the question. I went to the store and was going to buy some "Red Lead" (it has been a while since I did this) fill puddy and it sais "laquer" on it. Can I fill the minor imperfections with it and then wet sand for a coat of epoxy primer? o No: Any advice would be greatly appreciated. John Oxford, PA