1.6 Poston (T & D) Roller Rockers I bought these years ago at a swap meet, they were brand new. The previous owner wasn't able to figure out that one of the cylinders had two left rockers on it (see the silver rocker in pic). I ordered a replacement from T & D and shimmed it to center the roller on the valve stem. I doubt this this set up has a 1000 miles on it. I ran these on my high compression stock appearing engine that saw limited street used (sold that short block last year and now just running pump gas and stock rockers). Rockers have been clearance for larger valve springs. Prefer to deliver to the BPG this w/e but would ship. $400 or best offer including push rods.
Rob, I am interested. Are these full roller bearings in them and are they stock length push rods? When are you going to be at BpG?
They are full roller needle bearings, these are the early versions, sometime the bearings will migrate in board, I've move them outboard once. The newer versions and TA don't allow the bearing to move. The push rods are the ones that came with the rockers, I think they are slightly shorter than stock but the length is not measured end to end (technically speaking). I'm leaving for BPG on Saturday and coming home the same day. Does that help?
