I need shorter vent tubes. Do not want to cut the ones I have so I would like to put new ones in. Anyone know how this is done?
Doug, I believe these are just pressed in. Whan I bought a HP1000 from a board member the vent tubes were damaged in shipping. I bought new ones from holley and installed them myself.
maybe try a heat gun to expand the casting to make it easier to get in and out, maybe a little blue locktite to keep the new one secure. good luck
I guessed they are pressed in. Any big problem getting them out? Thought about applying a little heat (maybe with a heat gun.) I get real nervous about prying on a $900 carb.
Honestly Doug, I just used a pair of needle nose pliers and was able to pull them out. They were snug, but relatively easy.