Im selling my 15x7 Cragar SS rims that include caps lugs and tires. They are in good driver condition. They are GM bolt pattern and are off of my 79 Trans Am. Front Tires are 205/50/15 and rears are 275/60/15.Tires have alot of tread. almost new IM located in Nassau on Long Island $650 takes it Thanks~Vinny
Just for the record, Cragar wheels are "unilug". They will fit Ford, GM big car and intermediate and Chrysler. You just need to change the lugs and washers. It might broaden your market. Fits all- 5 on 4 1/2, 5 on 4 3/4 and 5 on 5 patterns
Jason...CRAGARS are my absolute favorite aftermarket wheel!!! ..and...you are mostly right however, SOME EARLY Cragars were NOT unilug..looking at the washers, they appear to be round, not oblique, so these may/may NOT be unilug?? ONLY IF the seller pulls one of the lugs off, we'll know for sure! Wheelz, Tampa Bay
The washers for the 5 on 4 1/2 pattern and the 5 on 5 pattern would be offset. The 5 on 4 3/4 pattern fits right in the middle so it has a round washer. The tip off is the two little bosses on each side of the washer. They are there to keep the offset washers from rotating. Yes, to verify 100%, take a lug nut off. If you see an oval hole, they're unilug and fit a multitude of cars. You can then list them on the Ford and Mopar sites as well :TU:
Too bad the tires were so small. I am looking for rims like these. I need bigger tires for my 66 Skylark. You might want to try posting on craigslist. That is were I have been looking. Good Luck, Bob
Jason is correct. I completly forgot that these are unilug. They will fit 5 x 4-1/2'', 4-3/4'', 5''. This will certainly broaden the sale.. Hopefully.. Id also be willing to trade for Torqu Thrust II wheels that have the center painted grey. Im prolly going to go with 17"x8". Thanks guys:beer
