Hey Matt,i had some replies to this question on the Bench section and i think I'm going to go with the suggestion of removing the old carefully with an exacto knife and then using 3M adhesive spray and a blow dryer to install the new ones.Sounds good anyway.I'll see how it works and let you know. :TU:
Jeff, Let me know how it works out. Were you going to remove the dash or try to install them while the dash is intact? I was removing mine since I had some bulbs to replace and I wanted to clean up the lenses. Matt
I installed mine with the dash installed. Just peeled the old ones off. Cleaned the suface with a solvent. Then applied the self stick new ones. Unscrew the chrome rings off the headlight switch and lighter. You can pull the rod out of the light switch if you like. On the climate control side, I unbolted the climate control module from the back of the dash(remove the radio for access) Then push the climate control back a little, and you will notice the plate on the front of the climate control is held on with small spring clip, top and bottom. Remove the plate and peel off the woodgrain, apply your new one. Reassemble, and you are done.
