does anyone make poly urethane motor mounts for a 455

Discussion in 'V-8 Buick Powered Regals' started by 455regal, Jul 23, 2006.

  1. 455regal

    455regal Well-Known Member

    Hi
    Does anyone out there know if anyone makes poly urethane motor monts for a 455 Buick. I checked energy suspention web site but didn't see any.
    Thanks Brad
     
  2. BADDABUICK

    BADDABUICK Well-Known Member

    I thought HNRPARTSNSTUFF.COM WAS GOING TO PRODUCE SOME
     
  3. Kerry s.

    Kerry s. Is Jesus YOUR Lord?

    Hi Guys,

    Brad.....Paul Ferry (owner of HRpartsNstuff) sent me a reply concerning the 455 poly motor mounts just last week.

    I've been "on him" about them for the past couple of years now. He'll get around to them, I have NO doubts but it will help TREMENDOUSLY if more of the BBB guys drop him an e-mail about them! HRpartsNstuff@aol is his e-mail address or you could always give him a call at the above number.:TU:
     
  4. Leviathan

    Leviathan Inmate of the Month

    There have been a few folks try the a method of drilling the mounts and putting in a safety bolt that runs through the rubber. In concert with a tie down cable you'll get a similar effect, not great, but about the best you'll get these days...
     
  5. 455regal

    455regal Well-Known Member

    thanks anyhow!!

    Thanks for the replies!! I ask because I built my own oil pan and messed up a little in measuring. It was 1/8 from the back of the crossmember on the corners. I pulled the motor ( 6th time!!!now) and cut and plated the crossmember. fits great now!!
    Thanks again Brad
     

Share This Page