Going on the dyno today

Discussion in 'The Bench' started by Eric Schmelzer, Mar 26, 2004.

  1. Eric Schmelzer

    Eric Schmelzer Well-Known Member

    On Monday I installed a new aftermarket intake on my Dakota. (This was done out of nessesity not want) I will be putting it on a chassis dyno at Ag & Auto Diesel here in North Platte, Ne. Just courious as to how much power it gets to the ground.
     
    Eric Schmelzer, Mar 26, 2004
    #1
  2. Stagedcoach71

    Stagedcoach71 Well-Known Member

    Blowers

    Eric:

    Is it the 4.7L?
     
    Stagedcoach71, Mar 26, 2004
    #2
  3. Eric Schmelzer

    Eric Schmelzer Well-Known Member

    Re: Blowers

    No, its the 5.2 Magnum(318) I replace the stock "Beer Barrell" intake with a new MP1 from Mopar Performance.





     
    Eric Schmelzer, Mar 26, 2004
    #3
  4. Eric Schmelzer

    Eric Schmelzer Well-Known Member

    results

    Made 147.2 horsepower, 878.7 torque.

    Remember this is on a chassis dyno so the tq readings are multiplied through the gaearing.

    Not what I was hopeing for on hp side but cant expect to much from a small engine with 100,000 miles
     
    Eric Schmelzer, Mar 26, 2004
    #4

Share This Page