hello, I am going this weekend to check out a 350 that was pulled out of a 1970 GS-350, and the current owner believes it is the original 315 hp engine-but isn't sure. I appreciate his honesty!!! Most people would probably just say yes. Is there a particular casting number that I can look for on the block and /or heads??? I could deal if it was the "normal" 285hp four barrel engine, but not the two sucker. any help would be appreciated. thanks james driscoll
Should be two letters (SP) on the drivers side block deck, I think it's right near the dipstick tube. Bring a small scraper with you to clean the gunk off to be able to see it. Good luck.....and congradulations! Mike
http://www.buicks.net/shop/engine_ident.html Code should be 'SP' for the 315HP engine. V8 - 350 4 315HP@4800 410FT/LBS @3200 Bore/Stroke: 3.800x3.850 CR: 10.25:1
There is a code on the block(SP)THAT IS BETWEEN THE #1 AND #2 SPARKPLUG on the block. Look between the exhaust manifold and the head and you will see a small flat area.This is where the code is .You will need a scraping tool and possibly a good flashlight to see it.Be careful not to scratch too much because the stamping is sometimes hard to see. Pat :TU:
another question- what are the other codes for the other 350's used that year??? for the above, are the same casting codes used in 1969??? thanks james