Looking for last couple of Items

Discussion in 'Parts wanted' started by 68Rivi_In_Cali, Jan 29, 2020.

  1. 68Rivi_In_Cali

    68Rivi_In_Cali Well-Known Member

    Getting ready to begin the 4 speed swap in the 70 skylark. Tracking down the last of it.

    -Dog Dish Hub Caps
    -Hurst Shifter arm 5335 (I have 2 other ones not sure if they will work in my 4 speed swap)
    -Manual Neutral safety switch and harness
    - Manual Trans Hump
    -Speedo gear for M20 trans with 3.42 rear
     
  2. Rocketscientis

    Rocketscientis Well-Known Member

    Your hump out of acme holes til Wile E. Coyote ships more
    Can get you template & dimentions... Doit yourself hole kit

    make certain you get the right length driveshaft also
    989 721 9432
     
    68Rivi_In_Cali likes this.
  3. Rocketscientis

    Rocketscientis Well-Known Member

    Didnt notice you....call or txt me plz...thanks jon
     
  4. 2manybuicks

    2manybuicks Platinum Level Contributor

    I posted a 5335 for sale a month or two back. check thread for pics.
     
    68Rivi_In_Cali likes this.
  5. flynbuick

    flynbuick Super Moderator Staff Member

  6. BrianTrick

    BrianTrick Brian Trick

    You can get a new 5335 shifter handle from the Parts Place. They are very nice. Not 100% correct in appearance,but for what you are doing,it will be fine.
    The switches and harness are available new.
    The repop hump that is available is a mid-60’s Chevelle hump. It will work if you enlarge the opening and massage it a little.
    If you are swapping from a TH350 to a small output Muncie 4-speed,then your driveshaft will be identical. If you swap from a TH400 to a large output Muncie,your driveshaft will also be identical,but your crossmember will come forward and you can either get the correct e-brake cables,or get creative with you cable routing. The 4-speed cars used the same front and intermediate cables as the TH350.
    You will also need a longer speedo cable to reach around to the passenger side. I have a NAPA number that works.
     
    68Rivi_In_Cali likes this.
  7. ToddsGS

    ToddsGS Founders Club Member

    If you decide to go with any of the TPP stuff let me know. I can save you a few bucks. I have the harness in stock also.
     
    68Rivi_In_Cali likes this.
  8. 68Rivi_In_Cali

    68Rivi_In_Cali Well-Known Member

    Thanks , I appreciate it!

    Going from a 350/ Th350 to 350/M20 I read it was the same length as my current combo.
     
  9. 68Rivi_In_Cali

    68Rivi_In_Cali Well-Known Member


    Will do! All the hardware I ordered from you came in nice and labeled. Thanks Todd!
     
    ToddsGS likes this.

Share This Page