Okay so I have to pute a master cylinder in my 72 skylark. Its got manuel drums all the way around. just wondering if there is any secrets to doing this other then bench bleeding. Is it pretty EZ
Nope just bench bleed the master and install. You might have to bleed the wheels too but maybe not, I've had it go both ways. When you bench bleed your master don't use the cheap plastic plugs in the line ports and bleed it. Make a couple lines from the fittings and curve them up to where they go into the fluid reservoirs (think a big loop) and bleed it that way. Works a lot better in my opinion. Bill