Miscellaneous parts I can deliver to Norwalk: - (2) 68/69 Skylark/GS passenger side doors. The green one has rust beginning to come through toward the rear edge (see picture) and has a small hole on the inside, front underneath the weatherstripping. The maroon door has no holes on either the front or back but there is surface rust along the entire bottom lip, although somewhat less than the green door. Both doors have the glass in them along with regulators, handles, door panels, etc. $50 each - (1) pair of 68/69 Skylark/GS front fenders. The green pass. side fender is very nice. It looks as though someone put a small patch over the top of the existing metal at the bottom - I have not taken the patch off but have included pictures of the back side. This one has all of it's trim on it including a nice marker light and wheelwell molding. The maroon driver's side fender is a little more rough. It looks as though the trim holes were welded closed. It could really use a lower patch panel. $75 each or $125/pair - (1) driver’s side 350 exhaust manifold shield, blasted and painted with Eastwood’s factory cast iron manifold paint. $40 - (1) pair of 455 valve covers, blasted and painted with Duplicolor Buick red, some pitting as seen in the close up pictures, no hardware, grommet or oil cap. $50 - (1) set of stock 350 pistons and rods, taken from a running engine, stamped “942”. $30 - (1) set of stock 455 pistons and rods, taken from a running engine, stamped “494”. $30 - (1) set of 350 main caps with stock bolts. $25 - (2) stock 350 flexplates. $30/each or $50 for both - (3) stock 455 flexplates, the bright red one has 2 elongated holes (see closeup picture). $30/each or $75 for all 3 - (1) pair of stock 455 pulleys, 3-groove crank pulley #1235777, 2 groove water pump pulley #1235778, excellent condition. $40/each or $60 for both - (1) stock 455 harmonic balancer, excellent condition. $50 SOLD - (1) pair of front drum brake assemblies (drum, backing plate, brakes and hardware, etc.), taken off my ’70 Sportwagon, completely rebuilt in 2000 including metal and rubber brakes lines, taken off the car and stored in 2004. These have 3" long, 7/16" studs. $150 I also have the rear drum brake assemblies from my Sportwagon if anyone is interested - again, completely rebuilt in 2000 and taken off the car in 2004, with 3" long, 7/16" studs. I can take pictures if interested. $125 In addition, I have the 10-bolt rearend from my Sportwagon. It's a non-posi rear with 2.93 gears I believe, backing plate to backing plate, no drums, rear was taken out of the car in 2000 when it had 57,000 miles on it.
Paul I'll take the better of the two doors which sounds like the maroon one. We'll be in Norwalk on Friday. Pmd you.
TTT I'll be leaving for Norwalk early Thursday morning so if there's any interest in parts, please let me know before then so I can bring them with me. I'm always open to offers.
