Im in the need for a good used 32 spline slip yoke for my Muncie swap. Its a 1973 Muncie so its got the Turbo 400 style output shaft. From my research, it should be a 3 5/8" barrel length and 5.5" from end to U joint center. FWIW, the factory part number is 7809762 Any help would be appreciated. Its the last piece of the puzzle!
If all else fails I have a bolt on yoke you will need to seal the end for fluid and use straps for the U joint?? $15.00 plus the trip. Med flat rate, I can't find any small flat rate that will hold the yoke.
if nothing else pans out I have this nice ... no seal groove .... correct one shown insertes in a 73 muncie wide ratio its 5.5 center to tip .... the tape measure musta retracted b4 I shot the pic... 3 5/8 seal area .... Scott best contact as I am not on here very often 2o6 465 9165 scott68gto@comcast.net
Make sure that yoke is engaged enough, my friend with his number-matching 71 Stage1 4-spd found out the hard way. It broke the tailhousing,ripped up his floor,and bent the driveshaft.