need help with a few wires in the engine harness

Discussion in 'Sparky's corner' started by jaye, Jan 13, 2017.

  1. jaye

    jaye Well-Known Member

    I purchased a harness from CARS for the engine 1969 Skylark 350-4, with A/C. I have everything wired except a couple wires I don't know where they go and some I need.

    -black wire with white tracer has a black rubber fitting on the end.
    -green & red wire terminating in a black clip with male blades inside. (short wires close to the wiper motor)

    Where do the wires for the blower motor resister come from
    where do the wires for the blower motor & the ones that attaches to the blades on the A/C box(4-blades)

    Thanks in advance
    pics would also be great.
    Jaye
     
  2. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD" Staff Member

    The black/white tracer is the THM400 kick down connected to the transmission case connector.

    Post pictures of the other wires, hard to say.

    Do you have a 69 Chassis manual?
     
  3. jaye

    jaye Well-Known Member

    I have the manual & I see the transmission wire you mention however, I have a T350 so I will not use that wire, the other wire I don't see I'll get a pic when I get to work tomorrow. The wire clip is close to the carb, was there wires that attach to the carb?
    Thanks for the reply.
    jaye
     
  4. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD" Staff Member

    The answer will be in your manual.
     

Share This Page