Now that the motor is in the car, I need some more parts: 4 Speed, no A/C 455: Fan pulley 7 blade fan Brake booster Check Valve "Z" Bar bushings and seals (already have the one for the ball stud on the engine. I need part #1386010 (Rod and Bushing assembly), 1369546 (seal), 1351769 retainer. Where is the best place to get new heater hoses, radiator hoses and fan belts? Len
Hi,do you need a single pulley or double.As for the fan,do you need a clutch fan or a standard fan.I have both in 7 blades and I also have the 2 pulley's.BrunoD.
Year one www.yearone.com or www.gmpartsdirect.com -- maybe www.thepartsplaceinc.com Unless a 71 is different there is no seal on frame side comparable to the engine side ball stud seal.
Len Kliner has the upper for 70-71 not sure on the lower . Underdog350 on this site has an add for his 72 style hoses . You might use his lower . I sent him the original heater hoses off my Suncoupe to see if he can get them repoed . I think someone has them already ( I have seen them on Ebay ) but I have not searched for a while .
Bushings I still need the rubber bushings that the clevis pins go into (there are two of them on the z-bar). The sleeves are ok but the bushings are shot. Can I get them at a local place? Len
Done. Knocked out the old bushing. Install a new rubber bushing with the existing sleeve. It cost me $ 4.50 from the Hardware store. It fits nice and tight and the sleeve aligns with the outeredge of the bushing. It is not factory correct; but, it looks pretty damn good to me. Len I'll take some photos when I get the z-bar installed.
