Turn signal lever

Discussion in 'Repro Parts' started by dl7265, Mar 8, 2019.

  1. dl7265

    dl7265 Gold Level Contributor

  2. flynbuick

    flynbuick Super Moderator Staff Member

    If my memory is correct it looks correct in terms of design but it is not the OEM length. Someone needs to verify my recollection.
     
  3. dl7265

    dl7265 Gold Level Contributor

    Thanks Jim , someone else told me the same thing .
    TPP 100% correct = 84% correct .
     
    Brett Slater and Smartin like this.
  4. UNDERDOG350

    UNDERDOG350 350 Buick purestock racer

    Unless they corrected it within the last 5 years it is about 1 1/8" longer than stock Skylark. I think they copied the part from a full size car. Look real nice though. I pulled the knob off, carefully ground down the OD of the shaft, cut the knurled section off, removed the excess length then welded it back together. Only spent about 2 hours reworking the 100% correct part.
     
    Last edited: Mar 16, 2019
    2manybuicks and dl7265 like this.

Share This Page