Hey, I was wondering if anyone had any Kenne-Bell adjustment screws and maybe locknut layin around that they might want to sell? I broke a few and am having trouble finding some that will work. I have a 215 V8 with kenne bell roller rockers they are the red anodized ones. thanks any help will work!
I think I have some extra's, I did run those but switched to Harlan Sharp. I'm in Texas this week and will not be back in Tennessee until next week. But I will try to remember and get back with you next week. Jim Netherland
Welcome to V8buick. If that don't pan out do a search on the board here on V8. There is a few posts where guys broke the KB screws and went to the larger adj. screws/nuts used on the TA rockers. TA used to sell them individually. The adj. screws must be the proper depth for valvetrain geometry and to ensure pusrod/cup oiling. I don't know about the KB screws but for the TA screws it is plus to minus one thread showing at the top of the nut. In otherwords the pushrod cup should be flush with the rocker to stabilize the screw as shown in this thread. (10 pics down) http://www.v8buick.com/showthread.php?215579-Retro-Kenne-bell-Dual-Quad-street-build& Ray
I'm hoping someone can help me as well. I'm looking for an adjustment screw for kenne bell roller rockers for a buick 350. I checked with TA Performance but I would rather not drill and tap.