Wanted: Nice pair of 430 rocker arms & shafts

Discussion in 'Parts wanted' started by STAGE III, Nov 5, 2018.


    STAGE III Lost Experimental Block

    I have a low mile 67 430 (carb to pan) but don’t wanna start robbing parts off of it.
    Gearing up for an engine rebuild so not a huge hurry but please let me know if you have a decent set lying around somewhere.

  2. johnriv67

    johnriv67 Well-Known Member

    Did the early 430 rocker arms have a different ratio than 1.55 or am I imagining that?
  3. Daves69

    Daves69 Too many cars too work on


    STAGE III Lost Experimental Block


    STAGE III Lost Experimental Block

    John, yes that was my understanding over the years but I am kinda like you so all I can say for sure is a "definite maybe":D
  6. johnriv67

    johnriv67 Well-Known Member

    I have heard 1.59 several times, but don't quote me. I've also heard the casting was exceptionally erratic.
  7. 41speciman

    41speciman Well-Known Member

    What year block are you useing for the build ?
  8. TrunkMonkey

    TrunkMonkey Well-Known Member

    Guten tag, Herr Fritzenheimer.

    I have a 1967 430 I am building, and using new parts on a short block so I have the top end and some other parts available.

    Valve train (pushrods to valves, no lifters) tall port heads (MPI, no cracks) as well as a good timing cover/oil pump and valve covers. I gauged the gears, within spec.

    Let me know if you are interested in some or all, and if you need anything else.

    Engine was in excellent shape out of a '67 Electra, and only required polish to crank and all bearings are standard and measured .020 clearances, so I am confident the top end is in good shape.

    STAGE III likes this.

    STAGE III Lost Experimental Block

    Herr Fritzenslimmer has pm’d ya heh heh

    STAGE III Lost Experimental Block

    Will call ya today, lots O stuff I can use there : )
  11. TrunkMonkey

    TrunkMonkey Well-Known Member

Share This Page