Who has correct upper A arm splashguards?

Discussion in 'Chassis restoration' started by Dan K, Jan 25, 2007.

  1. Dan K

    Dan K Well-Known Member

    I bought some from OPG, and they are the cheapest looking strips of low grade rubber stampings you can imagine, with round holes punched in so screws, and not staples would fit.... I know someone makes the correct material, because I have seen some restored cars with it. You know the stuff:it looks like they made it out of old tires and stapled it on the inner fenders. Does anyone know who has "the good stuff"? Thanks, Dan
     
    Dan K, Jan 25, 2007
    #1
  2. BADDABUICK

    BADDABUICK Well-Known Member

    Hi Dan I hope you get an answer i need them to ,i also bought some of the same junk you did .:cool:
     
    BADDABUICK, Jan 25, 2007
    #2
  3. mitch28

    mitch28 Well-Known Member

    www.gmobsolete.com sells the raw sheeting, you would have to trace and cut out the pieces.

    Mitch
     
    mitch28, Jan 25, 2007
    #3
  4. GStage1

    GStage1 Always looking for parts!

    Best ones I have found are from Parts Place for $10-15/set..includes staples but they are a slightly larger diameter. Use a drill bit to open the factory hole locations and you are set.
     
    GStage1, Jan 25, 2007
    #4
  5. Dan K

    Dan K Well-Known Member

    Thanks guys! Dan
     
    Dan K, Jan 26, 2007
    #5
  6. wkillgs

    wkillgs Gold Level Contributor

    CARS has the correct repos for $28.50, or a 28" x 43" sheet of the raw material for $28.....which is great for those of us with a fleet of '66's!:grin:

    http://www.oldbuickparts.com/catsky/sky08.pdf

    They're also the only (?) ones that have the METAL air cleaner decals!:TU:
     
    wkillgs, Jan 27, 2007
    #6

Share This Page