Jason I'm Already having this done .. Wish I'd seen ur thread earlier before you wasted your time :X DL
Well it looks like three guys are making these now. Another board member sent my dad a photo of the reproduction that he has already made using a 3D printer. I'll direct him to this thread.
Update- Here is my two piece prototype. Fits very nice and snug on my original battery cable. The finish is matte black and has a slight texture to it. So far so good. Next is to get it mounted in the car for thermal testing. Its really hard to take a picture of it. Might have to take some pics in the daylight tomorrow.
The prototype part was already in the works when I found out. At this point, Im going to proceed with installing it and testing it. Once that's done, I'll see where everyone is at with this.
I'm ready for one now if anyone has one for purchase. I can give feed back on fitment with my new repro engine harness. PM me if you can help. Thanks-Scott