All, I had this motor machined for my CJ7 but decided to go a different direction with it. This will be a great deal for someone. I'm asking 1900.00 for what I have. Machined Block bored 30 over. TA dual grove Teflon cam bearings are installed Forged SpeedPro pistons pressed on Factor reconditioned rods 3/4 groved hardened main and rod bearings Crank turned 10 under T/A 413 cam Lifters HV Oil pump heads cleaned up timing chain cover (factory used) Other misc parts I'm in Utah and would prefer not to deal with shipping. PM or Email me with any questions. --Rich
They are your standard dished forged piston. The comp ratio can be varied based on the head gasket. I was going to set it up as 10-1 with TA orange crush gaskets.
It's not sold, and I've decided I don't want to hassle with shipping. Local pickup, or meet 1/2 some where. I do have a trip planed for southern Cal in a couple months. Driving out, but would require pre payment before packing it all up To drag along with us.
Yeah, I really don't want the hassle of dealing with shipping it all. If I change my mind I'll let you know.
Adding some pictures: Still for sale, as mentioned I'll be driving to southern CA the day after Christmas. If you want to meet up in Vegas or somewhere of I-15 I'm happy to load it up and haul it to you.
Rich I'll get back in line. Can you tell me the numbers on the heads and block? Did the heads get a valve job or just cleaned up? What else is needed to complete the assembly of the block? Thanks Joe
Man I wish I had grabbed them, I putt all the parts back in the corner and have them bagged up. I'll see what I can dig up. The heads were done not just cleaned up. The motor is mostly complete minus an oil pan and rings. Everything that's in the picture as well as the following: Head Gaskets, Oil Pump/Water pump cover new Oil Pump Valve Covers Factory intake Factory rockers New Starter Alternator Etc..... Great deal for someone, first one to send money and that's willing to meet or pickup wins . --Rich
Nobody has stated at this point they want it or sent money. If you're interested and want to place a deposit it's open. If you're looking to build a 462 with forged pistons, this deal is a no brianer....... --Rich
As long as I am not cutting the line and nobody ahead of me has continued interest. I will send you a PM.
