I going to try to sell my 535 CI, 715 HP engine built by PAE and only dynod again. I put it up awhile back and had a few inquiries for both the upper and lower ends. I will sell the entire engine (if you want to check out original posting search for a 535 Buick) or I am now posting for the lower end. The block is bored to 4.35 and clearenced for a Modex billet steel forged crank with a 4.5 inch stroke and block is hard filled to 2.5 inches from the deck for strength. It has a TA lifter girdle installed and Eagle ESP forged steel H-beam rods with SPS bolts, ARP main studs, pistons are Ross stroker, 27 cc dome pistons, total seal rings, set up for external oil pump, Poston girdle oil pan, all oil modifications, decked, line honed, o-ringed and balanced. Everything is coated, cyclinders, bearings and pistons including ceramic coating. I have spent on the short block $9,711.42, This does not include the heads, intake, lifters, cam, timing chain or cover, flexplate, or harmonic balancer (internal balanced engine). External oil pump and Poston girdle pan are included. This was never installed in my car and Jim Burek at PAE can verify the information and even receive the engine, perform an inspection and ship on to you if you would like. I will sell it for $8,000 and include shipping costs up to $500. Thanks for looking and if I can provide you with more information PM me, Jim
