'55 Parting Out Chrome

Discussion in 'Classic Buicks' started by tbryat, Sep 16, 2004.

  1. tbryat

    tbryat New Member

    Hey guys,

    I've got a 55 Super 4 dr that I am parting out. Moving and can't take Humpty Dumpty with me. the bumpers will fit also fit 2dr supers and roadmasters---50 series cars and 70 series cars.
    The chrome was replated about 3-4 years ago and is in realy good shape.
    front bumper and all upper and lower rails
    rear bumper
    head light bezels
    tail lights
    mustache bar

    Also parting out stainless peices
    all window moldings
    door and fender moldings
    upper windshield reveal
    new old stock gas tank door trim

    Will part out and seel anything and everything on the car. Dash, steering wheel in good shape and the orig tube radio still works. Intake Carter carb valve covers, sheet metal etc. or sell whole car. Car is partly disassembled but runs.

    Thanks, email me if interested
     
  2. sue55buick

    sue55buick Member

    55 buick parts

    I am looking for the chrome tail lights and lens, front and rear bumpers rails and guards. I also need the inside door handle both parts. can you e-mail me a price list and shiping to North carolina.or sent to Bob Mcvicker 2824 Lautenberg Ln. Willow spring NC 27592
    Thanks Bob
     
  3. Vino

    Vino Well-Known Member

    sounds good

    Hello,

    Do you still have the rear view mirrow? Mine is aged quite a bit. And also I am looking for the upper chrome trim on the passenger side door. I have a '51 super, would this part fit? And do you still have the hub caps?

    On a side note, you wouldn't happen to have any engine parts from 40's buicks?
     
  4. tbryat

    tbryat New Member

    Hey, thanks for the replies.

    these parts won't fit a '51.

    Bob,

    I'll send you some pics of the parts. I'm in Charlotte, NC so shipping shouldn't be to expensive or you just get the parts you need. Look for pics in you email sometime in the next few days.

    Thanks,

    Tommy :cool:
     
  5. tbryat

    tbryat New Member

    $150 front bumper (replated-upper and lower rails-no bullet guards)
    $75 rear bumper (replated-no guards some rust)
    $150 mustache bar (replated - w/extentions for front fender)
    $30 Tail light pair (replated w/orig lenses-missing reverse light bezels)
    $20 Headlight bezels (replated)
    $10 Headlight bezels (pitted)
    $20 Trunk handle (replated- needs smoothing around edges w/emblem)
    $20 N.O.S fuel tank trim
    $100 Winshield trim upper and lower (stainless steel- all straight no dents)
    $30 All side body molding (some straight, some dented, some N.O.S)
    $30 Steering wheel (no big cracks w/center cone and emblem)
    $10 "super" script logos for quater panel - pair (pitted)
    & "buick" block letters for hood - set (pitted)
    $100 Dash board heat/vent control, glove box door and instrument cluster
    $50 Radio orig. still works
    $100 Front windshield- no cracks
    $100 Rear windsheild - no cracks
    $20 Valve covers
    $75 Intake manifold and rebuilt Carter WCFB carb


    OR $800 for whole car. Pricfec neg. Car will turn over and run, has water leak at water pump and tranny is sluggish, but it is a Dyna"shlush"
     
  6. 55buicksuper

    55buicksuper Joker (Poor Boys) TN Chap

    still have the chrome tail light housings? If you do, give me a call at 931-302-9279. Also looking for the speedometer cable and the 3 black heater knobs that go on the dash. impala65sscruiser@yahoo.com :TU:

    Thanks.
     
  7. tbryat

    tbryat New Member

    hey, I,ve been out of town for a while. Yes, I still have all the parts listed. The tail lights have the original lens - 2 pair. One pair has 3/4" holes in the center---some one tried to put blue dots in 'em.
     

Share This Page