67 GS Frame

Hi
This is a true 67 Hard Top Skylark GS frame. Scott [67 Grand Sport] had inquired about the frame and I will give him a few days to get back with me if he wants it. If anyone else has any interest in it please respond and you will be in line if Scott does not get back to me on it by 12-12-09. It still has the body on it right now so I will have to take it and the rear end off of it. The under side was under coated and is peeling in some places and gone in some places . It has a lot of surface rust on it but no rot or rust through. I will take $650.00 for the frame as is or I can sandblast it and paint it for an additional $450.00. The frame is located in eastern NC.
Thanks, Mike

 

ttt

 

do you want to sell the wheel well molds? thanks clydeo No:

 

I really dont know what condition they are in. I'll take a look at them next week and let you know. Are you looking for both sides on the rear or all four wheel openings?
Mike

 

Just the rears would be good, i have the fronts but there a little short, i did not know they are two peice's for a gs.:Comp: Thanks Clyde 401 438 8100

 

Just the rears would be good, i have the fronts but there a little short, i did not know they are two peice's for a gs.:Comp: Thanks Clyde 401 438 8100

 

the fronts are 2 piece, the rear lower pieces are about 6 in and pretty hard to get, theres 2 types, a cast piece and a stainless piece....

 

yes Thank You, i think i am going to cut a front to make the front bottoms:3gears:

 

Any luck on the rear wheel moldings? thanks Clyde ray:

 

Good Eye Clyde :kodak:

 

Clyde
Both rears are in good useable condition. The screws are rusted so I will have to drill them out. They need to be cleaned and polished. I'll take $50.00 plus shipping as they are or I can clean and polish them for 80.00 plus shipping. I'll take them off the car and post pics on Friday.
Mike

 

Could I be second in line for the moldings if Clyde passes?

 

Hey Mike Thank You so much! i have looked for these so long and hard its crazy. but i fond a set and jumped on them, so anyway Mike Phelp would love to buy these from you Mike. i cant beleive at the end i had a choice.ou: Thanks Clyde god bless

 

Put me next in line for the wheel well mouldings if the other guys pass, thanks!

 

Ragtops
As per board rules the moldings are your. Would you like them as are or cleaned & polished. It has been raining here and I have not removed them from the car yet. When it stops raining long enough to get them off I'll post pics.

Mike

 

I would be happy with them any way, and just as they are is good enough. I have sent you a PM with contact info.
Thank you very much,
Mike

 

Mike Phelps
Here are the pics of the wheel well moldings. There are a couple of the screw holes the are rounded out a little on 1 of them but that wont be an issue once there installed. There is also some pitting on the front of both moldings from possibly small rocks or sand. They will buff out fine though. If you would like them just let me know. You can call my cell # 919-920-9964 if you would like to.
Mike

 

Looks great, I will indeed buy them, PM sent.

 

Wheel wells sold.