This is a basic core carburetor that has been sitting in my attic for years. Not sure what it came off of but I had planned to rebuild it for use on my 66 Skylark with the 300 motor (but could never find a cast iron four barrel manifold). The part number is actually 3826S with an "A5" under the part number. $25.00 plus the cost of shipping inside of a USPS large Flat Rate mailer ($14.50 for shipping). I tried to use the medium flat rate box but the throttle linkage was too long for the smaller container. If anyone is interested I DO have a 4-barrel intake for a 340 Buick (cast iron).
free bump . got a pic of bottom with no gasket ? and i think some one up in the "small block" section was lookin for a 340 intake a little while ago ? del
Sorry about the delay in getting back with you. I took a few additional photos of the carb and pulled the gasket off the bottom. Needs serious cleaning! Alan R. Broadbent 2700 Oklahoma Street West Melbourne FL 32904 abroadbent@bellsouth.net (321) 427-3070