Help! yanked tube for vacuum advance out of 2GC

Discussion in 'The Mixing shop.' started by Wildcatnext, May 31, 2005.

  1. Wildcatnext

    Wildcatnext Active Member

    I did this after the rebuild of course. Is this tube press-fit in? It can't be part of the casting.
     
    Wildcatnext, May 31, 2005
    #1
  2. armyguy298

    armyguy298 Well-Known Member

    score the sides with an awl and punch and punch it back in, OR JB weld it.
     
    armyguy298, May 31, 2005
    #2
  3. Wildcatnext

    Wildcatnext Active Member

    Thanks-- I have the tube in more-or-less but I seem to have fuel pouring out from this location. JB Weld might be the way to go then.
     
    Wildcatnext, May 31, 2005
    #3

Share This Page