EDIT/ADD: SOLD... thanks very much. Here is a nice original 16" armrest setup.... >Nice plastic condition on the base - not dried out or chalky. A couple small chips here but nothing bad. >Clean - scrubbed inside and out >Includes nice stainless insert >Foam pad is soft and nice - I repaired one spot on the "grab" area that typically gets worn away....repair is good and won't be visible under new vinyl (I've repaired a lot of these pads over the years). >Metal baseplate had some rust on it so it's been beadblasted to bare metal and sprayed with a high quality catalyzed epoxy paint. Glue for the new vinyl covering will adhere well and won't hurt this finish. >3 original pad attaching screws will be included with this setup (not shown in the pics). NOTE: If you need new correct grain black vinyl for this (and your other) armrest pads I can include enough for BOTH pads with your purchase (no extra charge). $60 + shipping. Post interest ON THIS THREAD and we can discuss payment via a "Conversation".
Another pic for 1968_GS400....shows how the pad rests on the metal base....shown upside down as the grey metal pad base rests on top of the plastic armrest.
