Quadrajet Sale!!!! 800 cfm 7043240 and others. Fresh 'Built, ready to run.

Hi Ya'll. My convertible is at the paint shop, and I need to raise some funds quick to get it finished up.

I have several Quadrajets either fresh built or in progress to finish this week. These are built to stock specs with best available parts from Cliff or Greg. Each carb will have:

New Float
New high flow needle/seat
New accelerator pump/springs
New primary shaft bushings
New choke pull off
New gaskets
New fuel filter

Each carb is disassembled, soaked, cleaned, blown out, and lightly painted with carb renew.

this carb is 7043240 800cfm
73 jets
CT rods
H hanger

I also have:
another 7043240 800 cfm 455 carb
7041544 350
7044244 350

Will sell for $200 shipped in US with no core charge. I can also refresh your carb if you would like, or build just about any Buick carb, 2bbl or 4bbl.

 

To those that dont know. Mark built my carb, and its been great!

 

Thanks Curtis.

 

Interested pending p.m.

 

Thanks Dennis. Pm returned.

 

Interested but can you provide my choice of hanger and rods?

 

Yes, Herb, I can set it up with whatever you want. I have a good variety here. If I don't have what you need in stock, it would just take a couple of extra days.

What hanger and rods do you want?

 

Next 7043240 800 cfm is finished and ready

 

also interested. PM sent

 

PM sent!

 

Payment sent.

 

Payment sent, for the carb we spoke of, thanx Mark.

 

Thanks Dennis, carb is on the way.

Let me know if you are interested Herb.

Still have several 350 carbs in stock.

 

Lots of guys on here told me you were THE rebuild guy. Any chance you have a 4gc, I think is the right name, '64 300 4bbl with water choke for Skylark aluminum heads and manifold? I don't have a core. Thanks,

Michael

 

Michael, I can help you look for one. I have built plenty of the 4gc and they are getting harder to find and parts are tough too, but not impossible. Most of them don't have the ID tag anymore.

 

Thanks Mark,
I saw the one on e bay, but didn't know if that was a good deal or not. I noticed the listing showed no warranty, so I didn't know if that meant the rebuilder was questionable. I was looking at the one BillA had posted on here, but I think I missed that one. Mister T thought he had one at one time, but can't locate it. I was hoping one of the members might have one stashed, feel like I can trust you guys. I saw that $80 core on e bay also, wasn't sure. Seems like majority of advice is leaning toward the 4gc. Your thoughts since you build 'em?o No:
Michael

 

I rec'd the carb today. It's nicer than the pictures indicate. I'm running a performer intake (2146) so I suppose I'll need a spacer or adaptor of some sort? Advice appreciated. I can't wait to chuck my edelbrock carb and run this bad boy. Thanks again Mark!

 

The performer should have a dual pattern so it will bolt right on.

 

Sorry, I am a little late on this. Do you have anymore Carb's left? I am actually running a "mostly stock" 400 with an Offy intake manifold. Would the 350 carb supply sufficient fuel. I am looking for your recommendation on this.

Ryan

 

Hey Mark,
Put me in line for a 350 carb. I sent a PM about payment details.