http://s900.photobucket.com/albums/ac203/dave455gs/screamer/ Well I recently aquired one too many cars again. So my current project is for sale. It is a back half 1969 skylark, The Scrap Iron Screamer 2, currently it is a roller no motor or trans. It has 14x32 rear tires, 4:11 gears with a spool in a 12bolt rear, ladder bar with coil over suspension. Fuel system stays along with ignition control box, Set up for bb and t400, driveshaft is included. Car has been a race car for quite a while, Bill Lucky race cars did the chassis in Chicago. Car will come with a driveshaft 3" steel with 1350 Spicer yokes and joints(biggest and best available) Crossmember is included as well. The ignition system is all MSD: 7AL2 box, two step, and I just put in a start/retard box. This takes out 20 degrees of timing while cranking the engine, when the engine starts and goes over 1300 RPM the timing is restored. The guages are Auto meter ultra light mechanical oil and water temp and volt meter. (Tach also)I have installed the painless wiring kit and relay for the battery shut off switch to function properly and have run #4 wire back to the battery in the trunk for best charging with no resistance. Battery cable and grounds are all heavy duty and soldered connections. Mallory 250 fuel pump, filter and holly regulator with fuel guage in front of window . The shifter is a cheetah Turbo Action set up for reverse manual valve body with command center and fully wired. Scotts manufacturing electric fan attatched with a quick disconnect to make it a one pull item to remove. Car has a great trans cooler also. also included is micro swith attached to steering wheel with spiral cord for trans brake Tires have 5-6 passes on them from the previous owner. I have attached a link to some pics of the car. If there is something someone would like to see specific just let me know. I am asking $5800.00 obo. Can assit with deliveries.
http://www.modenamotorsports.net/racing.html Here's a link to a previous owner and a couple of shots of the car in action. Will include a really nice set of headers and some exhaust that bolts to headers and turns out the sides.
here is a couple pics, the exhaust might need some rewelding, these were on my regal with stage2 heads so I am not sure if they will just bolt on.
Mike, glen kept his motor. Pm me if you what to discuss further, I have a couple other interested parties not on this board.
Still for sale, plenty of time to drop a motor in for Norwalk Raceday. :3gears: Might take a convertible in trade or solid skylark, no parts cars. :TU:
