1. If you have recently registered with a gmail email address, you must contact me, as gmail will not forward our confirmation email to you. Contact me and jim@trishieldperformance.com to complete your registration.
    Dismiss Notice
  2. In and effort to reduce the spam on the site, several years ago I had went to a program where I manually approve each and every new registration. This approval gives you full access to the site, to pictures, and to post, among other things. To be able to enjoy the full potential of the board for you, you need to be fully registered.. and that's easy.. Just send an email to me at jim@trishieldperformance.com and I will verify your registration. This policy will remain in effect indefinitely, as it has completely eliminated the bad actors from our site, who would spam and hack it, once they gained access. Thanks JW
    Dismiss Notice
New users Registered with a gmail address Attention All new Users

serial #: 0061110

Discussion in 'Tomahawk Block Registry' started by badbuik, Dec 27, 2010.

  1. badbuik

    badbuik Well-Known Member

    As mentioned in another thread, my block was one of 2, personally delivered by Mike T., just after thanksgiving this year (2010). I'm building a 475ci. nitrous motor, my goal is to run in the 8.60 to 8.40 range, or quicker, with my '65 Skylark Convertible. I'm hoping a 54 mm cam core will be available soon so I can get that custom grind in the "works". Big fogger nitrous unit will be ordered by the end of the week, custom CP pistons, rings and pins should soon be done, and I already have a Moldex crank and aluminum rods anxiously waiting..
    Gary G.
     
    badbuik, Dec 27, 2010
    #1
  2. offbrand Racing

    offbrand Racing Platinum Level Contributor

    Gary,

    that is gonna be one bad beast to say the least!!! Who is doing the cam for you?

    Regards,
     
    offbrand Racing, Dec 28, 2010
    #2
  3. badbuik

    badbuik Well-Known Member

    Scott Brown at Competition Components (buyracingparts.com) is my guy! He did the solid cam I run now and I love it. I know he'll be able to give me a profile that will make great power. I just need that roller cam core..
    Here's his number if ya need it, he will help you make more power, and a great guy. (616)499-6223
    Gary G.
     
    badbuik, Dec 28, 2010
    #3

Share This Page