My 350 is getting rattly and smoking Looking for a good strong built motor Higher comp bigger cam better oiling Any one have one in the Northwest I'm in northern Idaho Just need long block Or recommendation on machine shop in this corner of the country that is familiar with Buicks and can do a good build Not after a $10k plus monster Thinking 2-3 range on build?? Or like I said one that is used and has been done Street racer every day driver not a drag car Have a 2004r with stall and 3.90 gears Come on Sean got anything laying around lol?
LOL yes I have some spares. 9.5:1 engine with ARP bolts in the rods, full machine work 30 over, TRW forged pistons, poston 114 cam, rebuilt but stock heads, only 2000 miles on the rebuild. Did 460 Hp and 450 TQ to the tires On Low boost. Or wait till I’m dyno my 13.8:1 compression 350, I will sell that one too once it’s tested. Huge cam, crazy modified heads, wild setup.
Not going to be boosting any time soon Just my ta intake headers and qjet And this is my daily driver except for when snow on roads so 13.8 is crazy but I do still need to beat those hemis on my way home from work I was thinking 10.1 and maybe as high as a ta310 cam
the 9.5 engine would be an easy 10:1 with a little head milling. Although it was boosted it’s still a healthy NA engine without boost. Swap any cam you want into it. $2500 For the engine less the intake manifold. Located in Edmonton Alberta. I’ve got low cost shipping through “uship” and I’m fully willing to help with crating it up I’ve shipped lots of engines. Sending two LS engines out this week.
