Will Chevelle or 442 wheel well moldings work

Discussion in 'Repro Parts' started by honest03060, Jul 14, 2010.

  1. honest03060

    honest03060 Active Member

    on a 1971 GS?
     
    honest03060, Jul 14, 2010
    #1
  2. Brad Conley

    Brad Conley RIP Staff Member

    Nope.
     
    Brad Conley, Jul 14, 2010
    #2
  3. Hawken

    Hawken Hawken

    What are you looking for? I mean, which wheel well mouldings? RF, LF, RR, LR, etc.
     
    Hawken, Jul 15, 2010
    #3
  4. honest03060

    honest03060 Active Member

    Looking for the RR (drivers side rear).
     
    honest03060, Jul 18, 2010
    #4
  5. Hawken

    Hawken Hawken

    O.K., the RR will be the passenger side rear and the LR will be the driver side rear. I will check to see which ones I have in the garage (storage). I know I have quite a few ... just not exactly which ones.
     
    Hawken, Jul 18, 2010
    #5
  6. honest03060

    honest03060 Active Member

    Thanks Ken,

    I may need both still taking to old ones off....
    any advise on careful removal?

    John
     
    honest03060, Jul 20, 2010
    #6
  7. Ryans-GSX

    Ryans-GSX Have fun, life is short.

    FYI

    spray PB blaster or WD40 on the screws and wait till next day to take off place a phillips head srcew driver into the head of the screw and hit it with a hammer this will break years of rust off and help loosen it up to unscrew it... Take your time and dont worry about hitting the screw to hard it will take it just fine.


    This is the way I have done it for years and it works for me. Others here can also give advice
     
    Ryans-GSX, Aug 15, 2010
    #7

Share This Page