I am starting to look at distributors for my SBB 350 build and was wondering why so many HEI reviews around the interweb for SBB’s gripe about...
Hi.. Thinking about selling my Progression Ignition distributor, HEI style (big Distr.Cap).. Comes complete with HT-leads (power connector...
What’s the best way to recurve a 1968 stock distributor to move 34-36 degrees of mechanical advance from 4600 rpm to 2500 rpm? I was reading...
Hey all, I've been working on adjusting the timing on my car, and with my first couple adjustments I've been getting a rattling noise under...
Works. Came out of a working motor but can probably use a rebuild to tighten everything up. Missing mechanical advance limiting ring. Nice core...
Subject says it all. Looking for a distributor for a 1969 GS400. Part No. is 1111335. I am planning to have it rebuilt and curved, so as long...
I have have been fussing with the timing on my 69 GS400 on and off for a few years now. I put a Pertronix setup in it. Works great. I have the...
Hey everyone. I'm doing a swap from my 231 v6 into a 350 Buick that I purchased into my 1978 Regal limited. This is not from car specified car. It...
New to Stage1 world, Currently have a Mallory HEI that prevents the use of the original forced air intake hits the snorkel on that side. Will...
So I'm doing some simple stuff to the stock engine and I'm thinking of taking a rebuilt one from OReilly's and throwing in a points elim kit from...
okay here we go got a 1970 Buick lesabre custom 4dr 455 just rebuilt the motor bored 30 over TA oil pump recipe and a TA stock type GM HEI...
Does anyone know how many teeth are on the distributor for a 300 engine? I know the 350 has 14 teeth, I just need to make sure I can use my 300...
Hi, I got a 67 Riviera with a stock 430. I has about 180.000 miles on it and it runs really quiet and nice. I have 10 degrees advanced timing at...
Could one of you geniuses please tell me if I have this correct? If I don't please tell me how the order should go. I'm thinking this could be my...
Looking to buy a distributor for a 70 GS 455, non-Stage 1 car. Either part number 1111984 or 1112027 would work. Build date for my car is 4th...
I ran into a problem. I'm a huge newbie and forgot to mark up the rotor on the distributor when I took it out... :Dou: Yeah I know rookie mistake....
I have a 72 GS 455, but she wont start. I just drove her yesterday no problem, then i get back in to start an hour later and she doesn't fire. The...
1972 buick 350 from a skylark going into my 83 regal my mech cant find a manual on the 72 skylark hes trying to figure out where to set the...
got a 1972 buick 350 from a skylark going into my 83 regal my mech cant find a manual on the 72 skylark hes trying to figure out where to set the...
