I'm looking for a good used 455 timing cover. I'm in Indiana.
455 complete motor - including carb, manifolds, pulleys, flex plate, AC components w/ bracket. Needs rebuilt or used for parts was left outside...
So I finally did it, I think I spun a main in the 1973 Rivvy. My goal is to pull the 455 and go through it but that's going to take some time and...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] I have a complete intake to oil pan 1975 455 with stock low...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] I have a set of fully rebuilt 73 heads...
After over a decade I finally have a Skylark (1971 Custom) again. Looking to buy a running 455 or 350 and a transmission to replace the current...
Ok the day is here. TA has my TE Stage 2 castings and is waiting for me to tell them what I'm going to use in them. I'm going to run race gas with...
[MEDIA] Found this bad ass GSX on YT. Says he has it all stock except for the cam, TH400, longtube headers and a H-pipe with 3 inch exhaust all...
Came across this video on Youtube: [MEDIA] It's a 440, unsure if it's bored and has open headers, but it sounds mean as hell! And it's not just...
1970-1972 Buick GS hood. I had it media blasted and had Rust Mort applied along with 2 coats of epoxy rust inhibitor primer. It has some pin holes...
Anybody have a block girdle they would like to part with? Called TA and these are on back order (too) and “can’t give an ETA because it is unknown...
Hey everyone, I want to know if it’s safe to use the tube in tube stock driveshaft from a 66 Skylark with 455 and a TA212 cam, a 2400-2800 stall...
1970 Buick GS 455 project. Needs quarter panels - needs complete restoration - comes with non-numbers matching 1970 455 SF code core motor and...
Hi all, i have rebuilt my engine and discovered the heads are cracked beyond reasonable repair. July last year ordered a set of aluminium heads...
Currently running a stock 455 with eldobrock intake and holley sniper TH400 transmission, 3:42 gear. I was wanting to change the camshaft to...
I am doing some low buck engine swaps using Buick 455 motors in non-Buick chassis. I like the Buick 455's not only for their torque, but also cuz...
Hello, Im putting a 455 out of a 75 riviera in my 1980 lesabre, and Im looking for as much info as I can get, but my main question atm is wioll I...
I'm getting .004 Main bearing clearance measurements with telescoping guage and outside micrometer. The crank mains has been ground to 3.240" ,...
